For OSMO finished furniture (most Nack Desks). We use OSMO PolyX Oil, Satin-Matt 3054.


OSMO is a natural product as is wood so aging, while minimal is normal. Skin oil can be minimized with the cleaning methods below but any wood finish will not protect from consistent use. OSMO however is very easy to maintain and repair with the steps below.


Cleaning As Needed

  • Vacuum or dust regularly.
  • Clean using diluted OSMO Wash and Care and cotton cloth. If you don't have OSMO Wash and Care, use a water dampened cotton cloth and rub with the grain to clean. Don't use any "solvents or cleaners."
  • Remove greasy or ground-in grime with OSMO Liquid Wax Cleaner


Refreshing/Repairing the Finish As Needed

Clean the surface thoroughly and allow it to dry:

  • Refreshing high wear areas:
    • Apply a small amount of OSMO Liquid Wax Cleaner to a white abrasive
    • pad. Rub this into the surface.
    • Allow to dry for 30 to 60 minutes.
    • Buff with a cotton cloth.
  • Repairing superficial scratches, stains or ground-in dirt:
    • Use white abrasive pad or fine steel wool to rub in a small amount of
    • Liquid Wax
    • Cleaner into the affected area.
    • Wipe up any excess immediately with a cotton cloth.
    • Buff with soft cotton cloth or white pad when dry.
  • Repairing deep scratches or stains:
    • Lightly sand the affected area with abrasive pad or, if necessary,
    • appropriate grit sand paper.
    • Sand until damage is removed. Sand to original finish grit if appropriate.
    • Then reapply one or two coats of Polyx-Oil as described above.